Guitar Pedal Setup

This information applies to all Guitar Pedals.  If you require specific guidance please see the User Manuals at the bottom of this page.

STEP 1:

Remove the pedal from the box and give it a quick visual inspection. Ensure that nothing was damaged during shipping.

STEP 2:

Connect a 9 volt, Boss-style, 2.1mm Barrel Jack (Centre-negative) [Not included] into the connector on the front of pedal.  Confirm power by pressing the bypass footswitch and look for the LED 'active' indicator.  Once power is confirmed, move to next steps.

STEP 3:

Connect a 1/4" Tip/Sleeve (TS) cable from your guitar to the input of the pedal.  Connect a second 1/4" TS cable to the output and connect the other end to your amplifier or another guitar pedal. 

STEP 4:

Make Rock n' Roll history.